Cooper-instruments-systems WTM 502 Wire Tension Meter Manuel d'utilisateur

66 WTM 502 QUICK-CHECK TENSION METER USER’S GUIDE http://www.cooperinstruments.com TEL (540) 349-4746 • FAX (540) 347-475

3. Use the Num and Adv keys to enter the Config password. Default is 0. After the number is displayed, press the Enter key . . . The follow

Reso Press the Reso softkey and you are prompted to enter a display, or count-by, resolution. Choose from Low, Medium or High. Low resolution provide

Exception: Sheaves match the wire diameter of the cable to be measured and alternate calibration is selected as per section 5.2. Insure that the wire

1. No wire calibrations are stored of the same diameter as the wire you are looking to measure, and 2. You do not have sheaves of the same diameter.

Display contrast too light Hold the Right Arrow key down while pressing the F2 key several times to increase the display contrast. If nothing occurs,

CF 142 13 V 08/09/05 8.0 WARRANTY REPAIR POLICY Limited Warranty

TABLE OF CONTENTS 1.0 INTRODUCTION ...1 1.1 Unpacking...

1.0 INTRODUCTION = Tip = Remember This manual covers the setup and operation of the WTM 502 Clamp Line Tensionmeter from Cooper Instruments. Th

1.2.1 Front Panel and Keys The front panel of the WTM 502 is shown in Figure 2. FIGURE 2. WTM 502 FRONT PANEL Following are descriptions of the

Sample display 2. This example shows the wire is a 7/16”, 6X19 stranded cable and the unit of measure is lbf. Place the WTM 502 so the two outsid

2.2 Measurement Practices Warning Do not apply tension greater than rated capacity of the instrument or overload damage to the sensor may result. Do

2.31 Top Level Softkeys Zero Press this softkey to zero the force display. You would usually press this at the beginning of a series of tension tes

To exit the check-tension mode, press any softkey to display the softkey labels, then press the Mode softkey to scroll to the next mode. The next mode

There is a keypad shortcut for increasing and decreasing contrast. While in normal display mode press the Arrow key and the 2nd softkey simultaneously