Cooper-instruments-systems MasterLink 3000 Wireless Load Cell Amplifier Manuel d'utilisateur télécharger pdf (Page 7)

CF 187 5 RevA

4.0 HARDWARE CONFIGURATION

4.1 Connector Alignment

As the MasterLink 3000 has been developed to provide a compact integration to connectorized strain gage

transducers, the connector has the ability to rotate to a desired orientation for the application. The connector

adapter is a pipe thread which screws into the connector plate block. To maintain the IP rating of the system, the

connector must always be tightened into the block and not loosened. In order to tighten the connector, a wrench

must used both on the connector plate block and the connector adapter. If for some reason the connector

needs to be removed, the threads must be cleaned and a new layer of teflon tape must be used.

4.2 Connector Wiring

Pinout:

1  Battery + (RED)

2  Battery - (BLACK)

3  -Excitation

4  -Signal

5  +Signal

6  +Excitation

CONNECTOR PLATE BLOCK

6 5 4 3 2 1

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Pas de commentaire

Cooper-instruments-systems MasterLink 3000 Wireless Load Cell Amplifier Manuel d'utilisateur Page 7