Cooper-instruments-systems LTL 730 Wireless Tension Link Load Cell Manuel d'utilisateur télécharger pdf (Page 12)

CF 150 LTL 730 9 12/08

Comm

The serial test is an internally conducted diagnostic that requires a jumper across transmit and

receive. This requires a plug or cable assembly. Pressing the Serial soft key accesses the following

soft keys:

COM1 Press this key to test COM1 in a loopback test.

COM2 Press this key to test COM2 in a loopback test.

To perform a COMM test, the unit must be configured to use RS-232 communications.

7.0 CONFIGURATION

The configuration menu is a group of settings that may be password protected if desired to prevent operators

from making significant system changes. It is used to configure the following:

• radio network

• resolution

• communication ports

• power up display mode

• units of measure

• power management

• password management

• system default reset

To access the configuration menu, press the Config soft key shown in Figure 5.

Figure 5. Accessing Config soft key and menu

The display prompts for a password. See Figure 6.

Figure 6. Password screen

Use the Num keys to enter the first character of the password and the Adv key to move to the next character.

When you are done press the Enter key and the soft keys shown in Figure 7 become available.

The default password is “0”. If the password has been changed and forgotten, contact Cooper Instruments for

assistance.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 28 29

Pas de commentaire

Cooper-instruments-systems LTL 730 Wireless Tension Link Load Cell Manuel d'utilisateur Page 12